Water Transfer Printing/Hydro Dipping/Hrdrographics is the technique to transfer the pattern of the film to any object surface. Please follow the steps
1. Prep, Prime, and Paint your object Besides of ABS plastic, all other materials need to be painted with oil base paint in order to proceed water transfer printing.
2. Cut the film in proper size for your object It's important to consider the height of your object. Make sure the film is much bigger than the cover area of your object.
3. Tape 4 sides of the film In case of the pattern distortion and scattering after spraying activator.
4. Distinguish the hydrophilic side of the film Wet and use your thumb and index fingers to pinch the film for few seconds. After released, the sticking side is the hydrophilic side of the film.
5. Lay the film on water for more than 1min WITH the hydrophilic side face down Tap/drive the bubble out under the film if there is any. The lower water temperature is, the more time required for the film stay on water.
6. Spray activator in fine mist form evenly on the film to activate the film
7. Dip your object in 40degree angle into water slowly and steadily
8. Slightly shake your object in the water for few seconds after fully immersed
9. Take out your object and rinse the object surface with running water of faucet or shower-head It's important not to touch or rub the object surface before it's dry during/after rinsing.
10. Let the object dry naturally or by oven
11. Paint the clear paint for glossing and/or protection purpose for your object surface
- 50cm width, 1unit is 400cm length, 2units=800cm continuous length in a roll, and so on...
- Suitable for WHITE / YELLOW / RED shades base color
- Good extensibility after activated
- Applicable with all brands of activators
- Sealed packaging to keep the film in good condition
Shipping Note: Shipping to Alaska, Hawaii, PO Boxes, and APO addresses is not available for this item
Warranty: 90 Day Woot Limited Warranty
